0:00 Rear splitter and skirt extensions
0:51 What the rear diffuser looks like
1:32 Stuff needed, see description
2:17 How to install side skirt extensions
5:44 Skirts done
5:58 How to install rear splitters
13:06 Splitters done
13:22 Comparing skirts with splitters
13:38 All done, final check

Front splitter install & header panel reinforcement:
   • C2Aero/Carter's Customs front splitte...  

Other 'stang stuff    • 1999 Ford Mustang  

Adding rear splitters and side skirt extensions from C2 Aero/Carter's Customs to complement that brand's rear diffuser. May complete the kit by adding their front end splitter at a later time.

Install not too bad, little patience and careful measuring and you can get it whipped. The skirt extensions will come with pre-drilled holes, but the Rear splitters do not.

BEFORE MOUNTING EITHER PANEL - Find a way to mock the panels up before drilling holes, like with tape, and find where exactly you would like to mount these to fit the look of your car best. This is up to you and your personal taste, but there may be variables like the offset of your wheels that may dictate how far out you would like these to stick out, as both these panels allow for a degree of freedom as far as mounting.

Stuff needed
- stubby #2 philips screwdriver
- drill and bit
- masking or duct tape
- marker
- measuring tape
- fastener pry tool