No one likes wires hanging around, let's route all the wires the right way under the A Pilar

Required tools:
- Long pilers to squeeze 2 top metal brackets holding the A pillar cover
- Phillips screwdriver
- Duck tape
- Upholstery stripper

Steps:
1. Remove passenger side fuse cover.
2. Remove the A pilar cover - grab firmly the cover up and pull hard - the first metal bracket should move a bit, then use pilers to squeeze bracket and pull it out. Do the same with the second bracket i.e. squeeze with pilers. The third bracket just pull to the side.
3. Pull the pilar cover up moving a bit to the sides it should easily detach.
4. Remove the roof lights cover - first the middle part by pulling downwards.
5. Use philips screwdriver to remove 2 screws holding the light box.
6. Install the microphone and dash camera, hide wires nicely.
7. Attach the roof light box back, checking if all lights work correctly.
8. Stick GPS aerial to the A pilar, I used duck tape to additionally secure.
9. Route all the wires nicely, use duck tape to secure wires to A pilar.
10. Put the A pilar cover back - start with the down side, then fit the 3 brackets into the matching holes (it is best to see if they fit from outside through the windshield) and then push hard the cover near the brackets.
11. Install the fuse cover back.

Enjoy!


Music:
Buddha by Kontekst   / kontekstmusic  
Creative Commons — Attribution-ShareAlike 3.0 Unported — CC BY-SA 3.0
Free Download / Stream: http://bit.ly/2Pe7mBN
Music promoted by Audio Library • Buddha – Kontekst (No Copyright Music)