In this video we give this 8th Gen 2022 Camry SXE a little personal flare with Butterfly Cherry Blossoms Vinyl Body Graphics.

Step 1 - Clean the surfaces and make sure to also clean areas where the vinyl will wrap at the seams.
We washed the car, clay bared and then completed a surface wipe with 91% alcohol.

Step 2 - Tape the decal in place with 3-4 pieces of painters tape. If working by yourself, work in a garage to prevent wind and use tape lengthwise when holding up your graphics with the transfer for maximum adhesion. When using a hinge method, half of the graphics will need to stay in place on the car as you pull the transfer paper off of the other side.

Step 3 - Once half of the graphics are free from the transfer paper, cut the transfer paper (do not cut the graphics or clear overlay membrane during this step), spray the car with a soapy water (very little dish soap 1 drop in a spray bottle). Make sure NOT TO GET WATER ON THE TRANSFER PAPER. Once surface is sprayed with soapy water start laying the graphics against the car as you maintain a level and straight path with the clear graphics overlay. Once the graphics overlay is on the car verify no wrinkles in graphics and proper alignment. The soapy water will help with allowing some adjustments to the graphics. Once alignment is proper use a light pressure scratch proof squeegee to remove water/ air trapped underneath the graphics. Work from the center (hinge point of graphics) towards the ends.

Step 4 - When all air and water is removed from the graphics, use low heat and start removing the clear graphics membrane/ overlay (similar to the transfer paper). Working from the end to the hinge point worked best for us.