This video shows the installation and set up procedure of the Singer 351G industrial four thread serger a.k.a. overlocker.

The machine head can be installed once the table and stand is assembled - see here for instructions -    • Industrial Sewing Machine Stand and T...  
Also, see here for instructions on building the thread stand and mounting the speed controller -    • Industrial Coverseam Sewing Machine -...  

Index:
0:00 - Introduction
0:31 - A look in the supplied box of bits
2:25 - Installing the base and rubber mounts
5:20 - Installing the scrap chute
6:01 - The speed controller
6:54 - Installing the machine head in the table
7:29 - A look at the machine head and plugging in speed controller
8:13 - Installing the foot lifter chain
8:49 - Installing thread and pulling it through
12:03 - Filling the head with oil and checking oil is pumping
13:53 - Test sewing
15:47 - Conclusion

Web site - www.institches.co.nz
If you'd like to support my channel, please visit - www.patreon.com/sewingmachines