Did you know The Phrozen Transform 3D Printer has the option to print on 2 build plates at the same time?

In this video I install the dual 5.5 inch panel option in the Phrozen Transform 3D Resin printer. I show how to install it and what pitfalls to look out for. Phrozen originally told us the swap could happen in 30 seconds, but it takes quite a bit longer.

If you want to support my channel please use the links below to purchase from Amazon...

Siraya Blu Clear v2 resin - https://amzn.to/35LLun8 - $50 x 2
Baggies - https://amzn.to/3fCsQ5B - $5
Jump Rings - https://amzn.to/3dC17js - $10
Ball Chain (Grey) - https://amzn.to/2STnnxw - $21
Ball Chain (Silver) - https://amzn.to/2WJVKIf - $9

If you like my hats here are some of the ones I've worn:

Atari Hat (from a different episode): https://amzn.to/3fSriEp
Atari Hat (from episode 1): https://amzn.to/3eScm7K

Some of my other normal supplies:

Food trays that I put in front of my printer to catch parts on. These are ridgid and therefore a little better at holding liquid and spills than the ones in my resin handling video: https://amzn.to/3lo3bQK

Rubber Mats - a lot cheaper than wham bam - https://amzn.to/3pmhfws
Metal Funnels - https://amzn.to/39ZU56y
IPA - https://amzn.to/2T0uFzS
Spray Bottles - https://amzn.to/2T2q7t2
Nitrile Gloves - https://amzn.to/2Tm6T0c
My Mask - https://amzn.to/3cgvWL5
Tea Strainer for Recycling IPA - https://amzn.to/3c7ZJFr

And this is my favorite resin: https://amzn.to/3kln4qe