Published On Sep 28, 2022
-In this video, removed the Factory Shocks struts and rear springs
-Installed the Airlift Bags temporarily only to remove them shortly after to sell and go a different route.
-Also figure out how I was going to go about installing the Height Sensors for the Accuair Air Suspension Management along with some wiring management
Here are some links to the Mag Daddy Magnets I was using for the wire managing for the height sensor wiring harness=
https://amzn.to/3SkSgro
https://amzn.to/3DZsPHq
https://amzn.to/3BLeV9c
==================================================
Don't forget to subscribe, comment, share and like. https://goo.gl/cTk6m1
More of my Lexus IS500 Launch Edition Build thread located on ClubLexus Forums:
https://www.clublexus.com/forums/buil...
find me on IG: @typerod
/ typerod
(Disclaimer: occasionally some links above may be affiliate links, which means I receive a small commission on a purchase without additional cost to you, if you buy something through my links.)
Check out my small webstore of products I build for the community:
https://specone.bigcartel.com/