Build a PC hardware monitor with these 2 easy-to-build designs that use a 5 inch 800 x 480 touchscreen from Elecrow. It primarily has the Raspberry Pi in mind, however it's a brilliant little screen which you can easily add to your PC for a small (but useful!) secondary display.

In the video I give a full review of the screen, then show you how you can make a frame for the screen using cardboard, and finish off showing the free software you can use to add hardware monitoring gauges to the screen.

The Elecrow 5" screen (model AUS25507D-1) is available on Amazon here; https://amzn.to/3LGo9IF

0:00 - 0:19 Intro
0:19 - 7:18 Elecrow 5 inch Screen Review
7:18 - 9:58 DIY Frame 1 (side)
9:58 - 10:53 DIY Frame 2 (desk)
10:53 - 11:27 3D Prints
11:27 - 11:56 Windows Settings
11:56 Software Setup

Here are links to the software I used in the video;
Rainmeter: https://www.rainmeter.net/
Rainmeter Gagues by RicardoTM: https://forum.rainmeter.net/viewtopic...
HWiNFO: https://www.hwinfo.com/

Whilst I have been supplied this product for review, I have received no other incentive/payment. I only recommend products I buy & would use myself, and all opinions expressed here are my own. This content may contain affiliate links that (at no additional cost to you) may earn me a small commission.

I’m not responsible for any damage to your screen if you follow the build & something goes wrong.

#pcmods #pchardware #elecrow