Published On Jul 20, 2021
Check out the other videos of this build!
Part 1: • Harley FXR Build Part 1 | Twin Cam Sw...
Part 3: • Harley FXR Twin Cam Build Part 3 | Ch...
0:00 Intro
0:22 rear wheel
1:23 rear brake
3:12 rear wheel mounted
4:13 going over front end
4:54 mounting front end
6:44 Installing handlebars/risers
8:30 talking about bar setup
8:57 front brake line install
10:29 carbon fiber dash insert
11:20 fuel gauge install
15:21 ignition system and body control module mounted
15:50 powder coating a few parts
17:54 loading the oven
18:39 finished product
19:21 Dyna brake pedal, foot control mount
21:22 Outro
Slowly adding more parts onto the bike. In this video I mount the rear wheel and brake caliper, the entire front end assembly which I built last winter, top it off with my handlebar/riser assembly. I also mount a new fuel gauge in my dash, powdercoat a few parts and mount the right side foot controls.
I'm using a motogadget M-unit blue for the body control wiring and a Daytona Twin Tec 1008 for the ignition.
The stock FXR brake pedal interfered with the trans case, so I'm using a pedal and mount from a dyna. I welded a block on the frame to accept the dyna controls and left the FXR crossmember intact.