This video is part of an end to end project series you can watch here    • My First 1911 80% Build  

One of the hardest parts about tackling a 1911 build was selecting parts. The compatibility, nuances of selection, and the fact they most don't come in a prepackaged upper or lower parts kit made it a little hard to learn. Not to mention 1911 parts are more expensive than parts for things like Glocks, so a mistake can get costly. Lets demystify that a little bit in this video, before we get to parts fitting.

Here are the parts that are on the finished build. Sorry I can't point you to where to get them.
- Stealth Arms 80% frame with standard style barrel seat
- Stealth Arms beaver tail safety
- Wolff service spring pack for 9mm 1911 (didn’t use mainspring housing spring)
- Wilson Combat factory plus grip screw bushings
- Klonimus G10 full size grips
- Fusion government tru-link stainless steel mainspring housing
- Fusion 1911 trigger upgrade kit with flat K hole trigger
- Wilson combat ambi high ride thumb safety
- Wilson combat flared magwell
- Nighthawk custom tactical extended magazine release
- Nighthawk custom complete pin set
- Nighthawk custom plunger tube
- TR Enabling 5” 1911 9mm build/conversion kit
- Nighthawk custom stainless firing pin stop with radius bottom
- Nowlin 1911 auto stainless firing pin
If after reading that list you think that I’ve missed something, I would suggest looking into what parts come in the TR Enabling upper kit, spring kit, trigger kit, and pin set.

Please Youtube, don't take this down again. I watched it tons of time and removed everything that could have possibly caused you to remove it last time. Most notably there are no longer any references to where you can buy parts. I am doing everything I can to comply!